ASME Basic Cal Blocks

 Used for Angle Beam DAC and TCG Calibration.

ASME Basic (Fig. T-542.2.1)

ASEM Sec V Articles 4, Fig. T-434.2.1, Article 5 Fig. T-543.2.1. Article 5 was revised in its entirety in 2002. Used for Angle Beam DAC and TCG Calibration.

Standard Materials:

  • Carbon Steel A36/1018
  • Aluminum 7075
  • Stainless Steel 304
  • Titanium 6/4
  • Inconel 600
  • Monel 400

Contains 2 slots one on each face and on three sides are drilled holes 1.5″ deep. The diameter of the holes is determined by block thickness.

Material ThicknessBlock Dimensions
1″ or less0.750″ x 6″ x 7″
Over 1″ through 2″1.50″ x 6″ x 10″
Over 2″ through 4″3.00″ x 6″ x 12″